User Manual - V2000-c Rfid Access Control

Connect a magnetic door sensor to monitor door status. When the door is forced open, the system can trigger an alarm output.

Enter Programming Mode →right arrow Press 4 →right arrow

Press * twice ( ** ) to return the unit to standard operation. Modifying the Master Admin Code V2000-c Rfid Access Control User Manual

Enter Programming Mode -> Press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . Adding Users (Card or Keyfob) Enter Programming Mode. Press 1 + [Read Card] + # .

(Note: this is an instructional and practical guide meant to complement the official user manual. Always consult the manufacturer’s manual and local regulations before installation.) Connect a magnetic door sensor to monitor door status

Move the internal jumper (often labeled or S16 ) to pins 1-2 . Power the device on and wait for the beeps. Power off again and move the jumper back to pins 2-3 .

| LEDs | Status | Meaning | |:-----|:-------|:--------| | Red only | Steady | System powered, idle mode | | Green + Red | Flashing | Card reading in progress | | Orange + Red | Steady | In programming mode | | Red + Green + Orange | Flashing | Initialization mode | | Green | Flash once | Access granted | Modifying the Master Admin Code Enter Programming Mode

involves proper physical mounting and exact wiring connection to an external power supply unit (PSU) and electric locking hardware. Mounting Instructions