Two Trees Sapphire Pro Firmware Upd Hot! (1080p)

A: This is usually a probe offset issue. You must measure the physical distance from the nozzle tip to the BLTouch pin tip. Compile this offset into your Configuration.h or use the M851 G-code to set it live. Remember to run M500 to save the settings to EEPROM.

Before updating the firmware on your Two Trees Sapphire Pro, make sure to:

Here is informative text regarding the firmware update process. two trees sapphire pro firmware upd

Improved support for BLTouch or 3DTouch sensors, making the manual leveling process less frequent. Common Update Paths

The file must usually be named Robin_nano35.bin for the printer to recognize it during the boot process. A: This is usually a probe offset issue

From your printer’s LCD: Go to Configuration > Store Settings (to save your PID, E-steps, and mesh bed leveling). Write down your current E-steps value ( M503 via USB).

Ensure your printer is connected to a stable power source. Step-by-Step Guide to Sapphire Pro Firmware Upd Two Trees Sapphire Pro Remember to run M500 to save the settings to EEPROM

Copy the .bin file onto the root directory of the empty, formatted TF card. 2. Flash the Firmware your Sapphire Pro printer. Insert the TF card into the printer's motherboard slot. Turn on the printer.

Always approach the update with a clear understanding of your mainboard and always have a fallback firmware file handy. With the correct firmware, your Sapphire Pro will deliver consistent, high-quality prints for years to come.