Gunnebo Speedstile Fl Installation Manual Jun 2026
: The floor must be level within +/- 5mm over the entire footprint of the SpeedStile unit.
Solution: Clean the optical lenses thoroughly. Check for misaligned cabinet walls.
The gates will perform a self-test routine. The wings will open slowly, find their mechanical limit stops, and close to establish the baseline home position. Sensor Calibration gunnebo speedstile fl installation manual
Connect card readers, biometric scanners, or ticketing systems to the digital input terminals on the main control board.
Inspect the casings and glass for transit damage. Report any defects immediately before proceeding with mechanical installation. 3. Mechanical Installation : The floor must be level within +/-
The finished floor must be perfectly level within ±2mm across the entire footprint of the turnstile array.
Mounting the moving barriers requires extreme care to prevent glass breakage and ensure smooth motor operation. Ensure the power is completely off. The gates will perform a self-test routine
Align the templates with the centerline. Mark the exact drilling positions for the anchor bolts and the entry points for the cable conduits. Step 2: Drilling and Conduit Placement
Connect the mains cable directly to the internal fused terminal block located near the base of the master cabinet. Ensure the grounding wire is securely bonded to the chassis earth stud. Low-Voltage Controls and Access Integration
| Parameter | Specification | | :--- | :--- | | | 230V AC 50Hz or 115V AC 60Hz | | Power Consumption | 200W operating / 20W standby | | Throughput (max) | Up to 40 persons/minute (Prox/Smartcard) | | Mean Cycles Between Failures (MCBF) | 4–5 million cycles | | Mean Time To Repair (MTTR) | < 30 minutes | | Enclosure Protection | IP34 (indoor), IP?? (outdoor variants) | | Operating Temperature | +5°C to +40°C (indoor) / -10°C to +50°C (outdoor) | | Operating Humidity | 95% (non-condensing) | | Materials | 304 Grade Stainless Steel, 10mm–12mm Tempered Glass, Anodized Aluminum Lid | | Maximum Reader Size | Lid mount ≤ 9.8" × 3.3" × 1.2" |
